Instruction manual

3
O p e r a t i o n a n d I n s tr u c t i o n M a n u a l
Granita Machine Page
Prior to starting this procedure, ensure that the shipping carton does not show any evidence of
damage due to dropping or mishandling. This may indicate that the dispenser was damaged during
transit and/or delivery. If any damage is visible on the shipping carton, indicate this on the shipping
receipt.
You can now proceed in the unpacking process by first carefully cutting the plastic strapping which
secures the carton top and bottom. After cutting these straps, lift the carton top straight up and off
of the dispenser.
After lifting the box off the machine, carefully remove the styrofoam from the sides of the machine.
Next remove the four plastic legs, technical and instruction manual, and any other items found in
the mix tanks.
Prior to choosing a location please keep in mind that your dispenser should be readily accessible
for periodic maintenance and have adequate space for necessary air flow. After selecting a
location, you are now ready to place your dispenser.
Place the machine at the desired location. Make sure that there is enough space for ventilation on
both sides (about 8” on each side for 2 and 3 bowl units). Carefully lay the machine on its back and
screw the legs to the bottom. Gently tip machine onto its feet.
To ensure the highest quality in the shipping of your unit, we have left the plastic on both the unit
and the drip trays for protection against scratching in transit. Please remove before operating
your machine.
Install the drip pans and cover grates onto the front of the unit.
Before connecting power to the machine, check the label on the back of the machine to verify the
voltage and amperage draw of the unit and then do the same for the electrical outlet. Carefully
inspect the power supply cord on your dispenser for any possible damage which may have
occurred during transportation. If ANY damage is visible, DO NOT plug the machine into the power
supply, contact your authorized service agent to replace the power cord.
MACHINE POSITIONING
UNPACKING
IMPORTANT
IMPORTANT