Instruction manual

12
O p e r a t i o n a n d I n s tr u c t i o n M a n u a l
Granita Machine Page
To adjust the density/consistency of the slush there is an
adjustment knob (Figure 13, #2) at the rear, right corner
of the dispenser (#1).
Turn the knob right (clockwise) or left (counter clockwise)
(arrow C and B) The consistency indicator (#4) will go up
or down (arrow D and E)
To firm up the product, turn the set knob counter
clockwise, which will move the indicator down to a higher
number position
To soften / warm up the product, turn the set knob
clockwise, which will move the indicator up to a lower
number position
NOTE: when using a new product, or on initial start up, it
is recommended that you set the consistency indicator to
the lowest/warmest setting and increase as desired.
Please note that the machines are pre-set at the factory
at a medium setting (number 2.5)
Fitting the lid over the tank (Figure 14):
1º Slide the rim into the slot situated at the back of the tank.
Lift slightly the front of the lid.
2º Lower the lid and fit onto the tank.
3º Insert the padlock into holes of the front rims of the tank
and the lid. Close it.
Note:
A. The lid can be turned back to front (reversible). Proceed
as above.
B. In order to take off the lid, the padlock must be opened
and released; then follow the instructions in reverse
order
Figure 14
TANK WITH PADLOCK
LIQUID DENSITY ADJUSTEMENT
Figure 13