Technical information

CARPIGIANI Operation Manual - LB 302, LB 502, LB 1002, LB 302 G, LB 502 G, LB 1002 G
Rev. 12/2002
Page 4
IMPORTANT!
Failure to follow operational and maintenance pro-
cedures may result in damage to the unit and/or
void your warranty. CARPIGIANI Corporation will
not be held responsible for any machine that is
not properly operated or maintained.
In the event this unit should malfunction, please contact
your CARPIGIANI distributor or an authorized service
agency.
PART 1
INSTALLATION
Before starting this procedure, carefully inspect the ship-
ping case to ensure the unit has not been dropped, tam-
pered with, or abused in such a way as to indicate the
unit may have been damaged in transit.
If you notice any damage to the outside of the ship-
ping case that may indicate possible hidden dam-
age, make a notation of the damage on the bill of
lading before signing. Contact the carrier immediately
and request an inspection of damage. If this procedure is
not adhered to you may forfeit your right to file a damage
claim and be responsible for subsequent repair costs.
UNCRATING
• The case is secured to the skid with strapping.
Use caution when cutting the strapping as it may spring
out injuring you or damaging the machine.
• Remove the case by lifting it straight up and away from
the machine.
• The machine is also secured to the skid with strapping.
Use caution when cutting the strapping as it may spring
out injuring you or damaging the machine.
• Free the machine from the skid.
• Remove the single screw at the bottom of each side
panel.
• Remove the panels by sliding downward slightly, then
pull outward at the bottom and allow the panel to slide
down.
• You may remove the protective plastic coating that has
been laminated to the panels by peeling it off.
POSITIONING THE MACHINE
• The freezer is equipped with 2 pivoting front wheels to
allow easy location. Move the machine to the desired
location.
• The machine must stand level. Check the level condi-
tion by placing a level on the top of the freezer at each
corner.
• Lock the front wheels to prevent the freezer from mov-
ing.
Accurate leveling is necessary to allow for correct
drainage of the freezer barrel and to ensure cor-
rect overrun.
Positioning the machine with pivoting front wheels
Uncrating