Use and Care Manual

How to Assemble and Operate the Vacuum

Fig. 1

How to Assemble and Operate the Vacuum

The vacuum, hose, wand and accessories are packed separately�

1� Push the hose cuff into the hose inlet on the top of the bag compartment

until it clicks into place (Fig� 1)�

On/Off Switch

1� To turn the vacuum on, push the power pedal on the top of the vacuum�

2� To turn the vacuum off, push the pedal again�

Full Bag Indicator

1� If the full bag indicator appears, change the vacuum bag�

2� If the full bag indicator appears, but the vacuum bag is not full, check the

hose for a clog�

NOTE: When cleaning with a tool (dusting brush, upholstery tool or crevice

tool), the full bag indicator may appear� In this case, continue

cleaning, as the indicator will likely go off once the tools are no

longer in use�

Variable Speed Control

To adjust the motor power, slide the variable speed control on the canister

body to the desired motor speed�

Suction Control

To adjust the suction level, slide the suction control switch on the handle to

reach the desired level of suction�