Use and Care Manual

Fig. 1

How to Replace the Vacuum Bag

How to Replace the Vacuum Filters

Fig. 2

Fig. 1

Fig. 3

Fig. 2

Fig. 3

Always operate the vacuum cleaner with a bag installed properly� Change

the vacuum bag when the full bag indicator appears or when suction power

is weak� The bag compartment lid will not close without a bag in the holder

or if the bag is not properly installed�

1� Disconnect the hose from the canister by squeezing the two tabs on the

hose cuff and pulling it out of the inlet (Fig 1)�

2� Disconnect the electrical cord on the hose cuff from beneath the carrying

handle�

3� Open the bag compartment lid�

4� Remove the bag holder by pulling it up and out of the bag

compartment (Fig 2)�

5� Remove the bag by sliding the cardboard collar out of the bag

holder (Fig 3)�

6� Slide a new bag into the bag holder until it clicks into place�

7� Insert the bag holder back into the bag compartment�

8� Replace the hose� Reconnect the electrical cord�

When to Change the Filters

At a minimum, it’s recommended to replace the HEPA Media and secondary

filters after using 12 vacuum bags� If someone in your household is sensitive

to airborne allergens, it is recommended to change the filters after every six

vacuum bags�

How to Replace the HEPA Media Filter

1� Lift up the two tabs of the filter cover to access the filter (Fig 1)�

2� Remove the used filter and discard�

3� Insert a new filter and snap the filter cover back into place (Fig 2)�

NOTE: Filters cannot be washed and reused�

How to Replace the Secondary Filter

1� Disconnect the hose from the canister by pushing in on the two tabs on the

hose cuff and pulling it out of the inlet�

2� Disconnect the electrical cord on the hose cuff from beneath the carrying

handle�

3� Open the bag compartment lid�

4� Remove the bag holder by pulling it up and out of the bag compartment�

5� Locate the filter behind the vacuum bag�

6� Pull the filter holder up and out of the bag compartment (Fig 3)�

7� Remove the used filter and discard�

8� Insert a new filter into the holder and slide the holder back into place�