User's Guide

Thuraya SatBridge Smart Terminal User Guide Introduction
Page 13 of 387
How to Connect Cables
1. Determine which length of the coaxial cable you want to use.
2. Connect one end of the cable to the Wi-Fi Hotspot and connect the other end to the Satellite
Antenna unit, as depicted in the image below. Press each end of the connector and it should
click into place. The 20-foot cable is depicted in the illustration below.
3. To change the cable on Thuraya SatBridge, put the cable removal tool under the cable
connector and pull the tool up until the end comes out from SatBridge terminal. Do the
same step on the other end of the cable. Now, bring new cable to be replaced, press
each end of the cable connectors on the unit, as shown above and the connector should
click into place.
NOTE: The SatBridge Smart Terminal supports only two cable lengths: 6 inches and
20 feet. Select the cable length you use in the Settings section of the SatBridge App.