Specifications

Hurricane Track SERVICING HYDRAULICS
52
• There are three hydraulic filters on the
Hurricane track machine. Two are
return filters and the other is a high-
pressure line filter. Replace all
hydraulic filters after the first 50 hours
of operation for a new machine.
Thereafter, replace all filters every 200
hours of operation.
• Unscrew the old filters and O-rings on
the return lines and discard properly.
Replace with new filters and new O-
rings. Screw in filters hand tight only.
Recheck oil level and refill if needed, as
described above.
• For machines equipped with the high-
pressure filter at the right, cover the
machine around the filter before
removing the cover to replace the filter.
When the cover is removed, oil in the
container will spill out on the machine.
• Loosen the nut at the top of the filter
unit. Remove the cover. Remove the
old filter and discard properly. Replace
with new filter.
• Clean up all oil that is spilled before
running the machine to prevent a fire
hazard.
OR
• For machines equipped with the high-
pressure line filter at the right, remove
the plate on the top by unscrewing it.
Then lift the old filter out and discard
properly. This design will eliminate
most of the oil spilling but some may
drip from the filter. Clean up any spilled
oil to prevent fire hazard.
• Replace with new filter, use only
manufacturer recommended filter.
Contact JP Carlton or your local dealer
HYDRAULIC HIGH-PRESSURE LINE FILTER
HYDRAULIC RETURN LINE FILTERS