Specifications

Hurricane Track SERVICING CUTTER WHEEL
45
TOOTH ARRANGEMENT
• Inspect pockets, teeth and bolts for damage
and replace as required.
• When replacing pockets, always replace
new pockets across form each other in order
to prevent vibration.
• Replacement teeth must be carbide tipped
and have like design as provided with the
machine.
• Use anti-seize on threads to prevent bolts
from “freezing up” in cutter wheel pockets.
• When replacing complete set of teeth, be
sure to duplicate original factory tooth
arrangement.
• Torque bolts to 150 ft. lbs.
opposing outside pockets carry like arrangements of teeth to cancel vibration (Hurricane TRX tooth pattern shown above)
• Straight teeth are mounted in TWO
OPPOSING OUTSIDE POCKETS.
• A straight tooth must have a 45° tooth
accompanying it in the same pocket set.
The opposite pocket set should have this
same combination of straight and 45° teeth,
except with positions reversed. Mounting
these teeth opposite each other on the cutter
wheel cancels damaging vibration.
• Two Remaining Outside Pockets must have
45° teeth overlapping the centerline of the
wheel to make plunge cuts possible. Mount
two left 45° teeth opposite two right 45°
teeth.
• All remaining pockets require 45° teeth
mounted away from the wheel.
• Always make sure the carbide tip is facing
the rotation direction of the cutter wheel.