Specifications

Hurricane Track SERVICING BELTS
33
Servicing Engine Belt
• There is a dust protection plate, in two
sections, that goes behind the engine sheave
and bolts to the engine belt guard using four
1/4” bolts and nuts. Loosen all four bolts
enough to be able to move the engine to
loosen the belt and remove it.
• There are two adjustment bolts at the front
of the machine attached to the engine
mounting bolts. The jam nuts on these bolts
are used to adjust belt tension by moving the
engine.
• Loosen the jam nut on the outside of the
plate on each adjustment bolt. Then turn the
jam nut on the inside of the plate to move
the engine back toward the cutter wheel to
relieve pressure on the engine belt for
removal. Turn one adjustment bolt’s jam
nut a small amount and then turn the other
adjustment bolt’s jam nut the same amount;
working back and forth making adjustments
until the engine has been moved enough to
loosen the belt.
ADJUSTMENT
BOLTS AND
JAM NUTS.
LOOSEN NUTS ON DUST PROTECTION PLATE – 4 PLACES
LOOSEN THE
OUTSIDE JAM
N
UT
TIGHTEN
THE INSIDE
JAM NUT