Specifications

Hurricane Track TROUBLESHOOTING GUIDE
31
COMPLAINT CAUSE CORRECTION
Loss of oil pressure.
• Hose leaking oil.
• Hydraulic oil level low.
• Oil filters dirty or clogged.
• Oil cooler has a leak.
• Pressure switch wires loose
or broken.
• Pressure relief valve dirty.
• Check all hoses for leaks
using a board or cardboard.
DO NOT use hand or
finger. Replace hose as
necessary.
• Replenish tank.
• Replace oil filter.
• Check and repair.
• Check and repair or replace
wire if necessary.
• See Servicing Hydraulics
for cleaning the valve.
• See PT Tech Manual
provided in this manual for
further information.
Power light goes out on PT
Tech control panel.
• Bad fuse on wire.
• Loose or broken wire.
• Remove control panel
cover, check and replace
fuse.
• Remove control panel
cover and check wiring,
repair if necessary.
Read PT Tech HPTO
manual for further
information (provided at
back of this manual.).
Roar in machine when
cutter wheel is engaged.
• Belt guards or dust plates
rubbing on jackshaft or
cutter wheel shaft.
• Jackshaft or cutter wheel
bearings going bad.
• Re-position away from
shafts.
• Contact your dealer or JP
Carlton.
Bearing will not take
grease.
• Grease fitting clogged. • Replace grease fitting
Track too loose.
• Tensioning cylinder too
low on grease.
DO NOT OVER GREASE
TRACKS WILL BOW
• See Track Maintenance
section in this manual.
Traction loss of power.
• Hydraulic motor worn. • See Track Maintenance
section in this manual. for
information or contact your
Carlton dealer.
ONLY USE QUALIFIED PERSONNEL TO WORK ON HYDRAULIC SYSTEMS
FOR REPAIRS OR REPLACEMENT OF PARTS!!