Specifications

Hurricane Track MACHINE OPERATION
25
• Continue cutting the stump by adjusting
the cutting head progressively lower
until the stump is cut well below ground
level.
• Raise and swing cutter wheel clear of
stump and position machine closer to
stump for next series of passes. Lower
and continue cutting.
• Continue in this manner until stump has
been removed.
• Larger stumps may require repositioning
machine to work at best advantages.
• IF RED LOW BATTERY LIGHT
LIGHTS UP ON THE TRANSMITTER,
THERE IS APPROXIMATELY 20
HOURS OF BATTERY POWER LEFT.
• Raise cutter wheel clear of stump and
return to center position. On the radio
control transmitter, put the Swing Brake
switch in the LOCK position before
moving or turning off the machine.
• Reduce engine speed to idle. DO NOT
TURN OFF MOTOR. Engine must be
allowed to cool slowly at idle for 3-5
minutes to avoid damage.
• With engine at idle (below 1100 RPM),
disengage clutch by pushing the switch
down on the radio control transmitter.
The clutch will disengage immediately
and the Clutch Engage light will go off
on the clutch control panel. The cutter
wheel will take several minutes to come
to a complete stop.
• Move the machine away from the work
area after the cutter wheel has come to a
complete stop.
• Turn off machine using key on machine
control panel. CLUTCH MUST BE
DISENGAGED BEFORE TURNING
MACHINE OFF. Allow cutter wheel to
come to a complete stop before
inspecting the work area.
DISENGAGE CLUTCH WITH ENGINE AT IDLE. CLUTCH
MUST BE DISENGAGED BEFORE TURNING ENGINE OFF