Specifications

Hurricane Track MACHINE CONTROLS
19
TROUBLESHOOTING
SEE THE RADIO CONTROL MANUAL
FOR ANY OPERATING PROBLEMS
WITH THE RADIO RECEIVER &
TRANSMITTER
(Included in the back of this manual)
• Contact your Carlton dealer if you need
assistance not the radio control
manufacturer.
• Check the batteries to make sure they are
providing enough power to operate the
transmitter.
• There is a low battery light on the
transmitter, when it starts flashing you
have approximately 10 hours of
operation before the batteries die.
• Remove the cover on the transmitter.
Remove old batteries and replace with
new batteries. The transmitter operates
using 4 - “C” alkaline batteries.
• Next, open the cover on the machine
control box. You will need to be able to
see the lights on the receiver to compare
to the trouble indicators on the receiver
diagnostic list in the radio control
manual. Check the light configuration
and compare it to the Diagnostic lists in
the radio control manual. If necessary,
check the Expansion Module in the same
manner.
• If the radio receiver or expansion
module status light is flashing red, a fuse
is blown. To change a fuse, remove the
unit from the cover and change the fuse.
Inspect wiring for short circuits (e.g.
bare wires). If problem re-occurs, call
for service. Push the unit back up into
the cover until the tabs snap back into
place.
• Always replace the machine control
panel cover when service is complete.
DO NOT RUN MACHINE WITHOUT
ALL GUARDS & COVERS IN PLACE
AND SECURED.
REFERENCE THE LIGHT CONFIGURATION ON THE
RECEIVER TO THE DIAGNOSTIC CHART IN THE RADIO
CONTROL MANUAL
RELEASE THE RADIO RECEIVER CAP BY UNLATCHING
THE TABS ON EACH SIDE AND DROP THE RECEIVER
UNIT DOWN FOR SERVICE
REPLACE FUSE
LOW BATTERY LIGHT
REMOVE THE BACK COVER TO ACCESS THE
BATTERIES – THERE ARE 4 SCREWS HOLDING IT IN
PLACE. THE BATTERY COMPARTMENT IS LABELED
FOR CORRECT BATTERY ORIENTATION.