Specifications

Hurricane Track MACHINE CONTROLS
13
SWING PADDLE
• The swing paddle controls the rotation
and moves the machine back and forth in
a right and left direction as well as a
continuous 360° rotation.
• The swing knob controls how fast the
machine moves back and forth when
operating the swing paddle. Turn the
knob clockwise to increase swing speed
or counter-clockwise to decrease swing
speed. The swing needs to be set at a
speed that will allow smooth sweeping
cuts across the stump. If the machine
swings in jerking or jumping
movements, reduce swing speed.
SWING SWITCH
• The swing switch locks or releases the
swing brake. The Swing Brake must be
locked to start the transmitter. Keep the
swing brake locked when the engine is
turned off; if a person must be close to
the machine for any reason; the machine
is being transported; for travel to, from
and around the job site; or if the machine
is to be serviced. The brake must be
unlocked to operate the swing paddle
and move the machine from left to right
to grind the stump.
HEAD (LIFT)
• The paddle marked Head lifts the cutter
head up and down. The switch marked
Head controls the power supplied to the
paddle. To decrease lift speed push the
switch to low or creep.
BLADE
• The Blade paddle operates the scrape
blade, when supplied, moving it up and
down. Use the scrape blade by pushing
the paddle in the DOWN direction, as
marked on the transmitter. When not in
use or when moving the machine, raise
the scrape blade by pulling the paddle in
the UP direction, as marked on the
transmitter.
SWING SPEED SWING BRAKE SWITCH
SWING PADDLE
HEAD (LIFT) SPEED
HEAD (LIFT) PADDLE BLADE PADDLE