Specifications

Hurricane Track MACHINE CONTROLS
12
HYDRAULIC CONTROLS
• A series of hydraulic controls are located
on the radio control transmitter and are
clearly marked for operation. All
machine controls are operated from the
radio control transmitter.
RIGHT TRACK – LEFT TRACK
• The radio control transmitter has right
and left track paddles as well as a paddle
for both tracks. To operate the paddles
push them toward the direction you want
to move (Fwd or Rev). Use both right
and left track paddles in the same
direction (Fwd/Fwd or Rev/Rev) to
move machine forward or reverse. Use
paddles opposite (Rev/Fwd or Fwd/Rev)
of each other to turn machine either right
or left. When rotating the machine, do
not leave one track stationary while
rotating the other one around it as this
could cause the machine to jump a track.
If it is desired to spin the machine,
counter-rotate the tracks.
• The Both Tracks paddle will move both
tracks in the same direction, forward or
reverse.
• The neutral Tracks knob will allow the
operator to turn the tracks left or right by
twisting the knob in the left or right
direction.
• The Track HIGH (speed) switch will
reduce the power of the track function
paddles. The High position is for
maximum power (speed) to move the
machine quickly around the job site.
Use the Low or Creep speeds for easier
placement around the stump or for more
climbing torque.
GEAR
• The Gear paddle allows the operator to
change from low to high gear. In low
gear the tracks have maximum torque
and more climbing power while in high
gear the tracks provide maximum speed.
LEFT TRACK
RIGHT TRACKBOTH TRACKS
NEUTRAL TRACKS TRACK HIGH (SPEED)
PADDLE FUNCTIONS
GEAR
SWITCH FUNCTIONS
THE RADIO CONTROL TRANSMITTER WITH YOUR
MACHINE MAY LOOK DIFFERENTLY. THE SPEED
CONTROLS KNOBS MAY BE SWITCHES INSTEAD BUT
THEY WILL PROVIDE THE SAME FUNCTION.
NEVER WELD ON A MACHINE WITH
RADIO CONTROLS WITHOUT FIRST
DISCONNECTING THE RECEIVER WIRE
HARNESS, OTHERWISE THE RADIO
RECEIVER WILL BE DESTROYED.