Specifications

Hurricane Track SAFETY PRECAUTIONS
8
• Battery fumes are explosive. Recharge battery in an
open area away from fire, sparks, or other sources of
ignition.
• Battery acid can cause severe burns. Keep away from
eyes, skin, and clothing.
• Always remove battery before welding on equipment.
• PT TECH HPTO WARNING: to avoid any electrical
malfunction, the user should disconnect the wiring
harness from the controller when welding on the
equipment. Failure to do so may result in loss of
controller warranty.
• DO NOT OPERATE THE ENGINE AT AN
ANGLE GREATER THAN 25° OR SEVERE
ENGINE DAMAGE WILL OCCUR. PROPER
ENGINE OIL LEVEL MUST BE MAINTAINED TO
ACHIEVE MAXIMUM ANGLE OF OPERATION OF
25°. (See Engine Owner’s Manual for proper oil level.)
• Never allow spectators to stand and watch machine in
operation without proper hearing and eye protection
and standing at a safe distance. Flying debris may
cause severe injury.
• Do not operate around water, gas, power or phone lines.
Check with property owner or call utilities if not sure.
• Avoid fences and clear away other objects (i.e. sticks,
stones, metal, etc.).
• Be aware of the possibility of foreign objects imbedded
in or buried around the stump. Do not cut crosswise of
roots above ground to prevent roots being thrown.
• If unusual vibration occurs, stop engine immediately
and correct problem before continuing operation.
• Keep all guards in place and properly secured during
operation.
• Keep all safety devices working properly and all other
machine parts in good working condition.
• Never leave the controls unattended while in operation.
Be sure machine is not capable of operation when left
unattended.
• Stop engine and remove key when repairing or
adjusting machine or drive belts.
• Keep engine in good condition, service as instructed in
engine manual.
• Do not touch engine while running or hot (serious burns
may result).