Specifications

I & M BULLETIN
CMCCU-004
BASIC CONTROLLER
Page 3 of 3
For 072 teeth, set the dials as follows:
0 7 2
6. Install the Microprocessor Controller
in a location in the customer’s control
panel that will provide visual
accessibility. The customer’s control
panel opening cutout, thru hole
diameters and depth dimensions can
be found on the controller mounting
drawing at the end of this document.
7. Slide the controller through the opening
in the machine’s control panel.
8. Connect the Deutsch 12-pin connector
from the wiring harness to the back of
the microprocessor controller.
WARNING: to avoid any electrical
malfunction, the user should
disconnect the wiring harness from the
controller when welding on the
equipment. Failure to do so may result
in loss of controller warranty.
9. An optional remote engage/disengage
button (customer provided) can be
used, in addition to the button that is
integrated on the front of the controller,
to engage and disengage the clutch.
Refer to the Operating Instructions
section of this manual.