Specifications

I & M BULLETIN
HPTO8TD-100
HYDRAULIC POWER TAKE-OFF
Page 9 of 9
15. Install backplate (Item 14) over shaft
end and into piston cavity.
ATTENTION: do not pinch o-ring in
O.D. groove of fixed end plate and
o-ring on shaft while installing.
16. Install piston (Item 9) into dowel pins
of endplate (Item 3). ATTENTION: do
not pinch o-ring in I.D. groove of
piston while installing over shaft.
17. Using spanner wrench install clamp
nut (Item 35) onto end of shaft.
Tighten locknut until backplate (Item
14) stops moving.
18. Torque lockscrew on clamp nut (Item
35) to 70 lb-in.
19. Install o-ring (Item 40) into
accumulator piston (Item 20) and
insert into endcover.
20. Insert gray round wire spring (Item 23)
into accumulator piston (Item 20) and
endcover.
21. Install qty. of 4, hexhead capscrews
(Item 46) p/n HHD08-06C36-XX and
Manifold Assembly (Item 45) to the
top of the endcover. Torque bolts to
47 lb-ft.
22. Follow Installation Instruction (at the
beginning of this manual) for mounting
the HPTO10TD to the engine.