Specifications

I & M BULLETIN
HPTO8TD-100
HYDRAULIC POWER TAKE-OFF
9/11/2007
5
of
5
9. Remove all seals from piston, shaft
and backplate (Items 25,17 & 18).
10. Remove quantity of three springs
(Item 21).
11. Remove endplate (Item 8) by utilizing
the 3/8-16 threaded holes in the
endplate and ½-13 threaded hole in
the end of the shaft.
ATTENTION: The endplate is a
press fit and will require a fixture to
remove the endplate from the shaft.
12. Remove key (Item 14).
13. Remove retaining ring (Item 26).
14. Push shaft 1” axially toward the
endcover (Item 6). The I.D. of bearing
(Item 2) will then be loose. Remove
Ball bearing.
15. Move shaft axially 1” back into
position so the retaining ring (Item 19)
can be removed.
Important: retaining ring must be
removed from shaft or damage will
occur when removing the shaft.
16. Remove seal (Item 15).
17. Press shaft (Item 7) out of endcover
(Item 6) by pushing the shaft axially
towards the endcover.
18. Remove qty. of 2, hook ring piston
seals (Item 20) from shaft.
19. Remove spherical roller bearing (Item
11).
20. Remove two retaining rings (Item 33 ).
21. Remove two seals from endcover
(Items 12 & 13).
22. Clean area around manifold and
endcover.
Important: Keep endcover and
manifold ports clean and free from
debris.
23. Remove four bolts (Item 38) from
manifold and remove manifold (Item
37).