Specifications
I & M BULLETIN
HPTO8TD-100
HYDRAULIC POWER TAKE-OFF
9/11/2007
4
of
4
MAINTENANCE INSTRUCTIONS
The HPTO requires simple routine
maintenance by maintaining the proper oil
level in the hydraulic reservoir and
replacing the oil filter when required by the
equipment manufacturer. Maintenance
and inspections should be performed as
follows.
Daily Inspection:
The following items should be checked
daily.
1. With the clutch disengaged and the
ENGINE OFF in a cooled condition, the
oil level indicator on the oil reservoir
should be visually checked to insure
that the oil level is at the proper level. If
needed, add additional oil to the
reservoir.
500 hours of operation:
The following items should be checked
after the first 500 hours of operation and
every 500 hours after that:
1. Check all HPTO bolted connections
and hydraulic connections.
2. Change the equipment system oil and
filter per equipment manufacturer’s
recommendations.
5000 hours of operation:
The HPTO unit must be serviced and
inspected after 5000 hours of operation. If
the HPTO unit is allowed to operate
beyond this point, the torque may drop
rapidly and possible damage to the unit
could occur.
SERVICE INSTRUCTIONS
The HPTO can be reconditioned in the field
or sent back to PT Tech. Contact PT Tech
if any portions of these service instructions
are unclear.
DISASSEMBLY INSTRUCTIONS
Refer to exploded view drawing
HPTO8TD-100 sheet 2 of 2.
1. Carefully remove all wiring and
hydraulic hose connections to the
manifold. ATTENTION: Leave
manifold mounted to the HPTO at
this time.
2. Remove speed pickup sensor (Item
27).
3. Remove sheave and QD bushing from
the shaft.
4. Use lifting device to support HPTO
then remove all housing bolts (Item
22).
5. The HPTO can now be removed from
the engine and placed on a suitable
working surface.
6. Remove o-ring plug (Item 28) from
shaft end. Important: keep area
around the o-ring plug clean and free
from debris.
7. Loosen bolt on clamp nut (Item 16)
and remove clamp nut off of shaft.
8. Remove piston (Item 9) from shaft.
Note: Install qty. of 3, 3/8-16 threaded
bolts into holes in piston to assist in
piston removal.
Note: backplate (Item 10) will come off
with the piston.