Specifications

MACHINE MAINTENANCE
10
− To adjust V-belt tension, loosen the four bolts
on the engine plate (See Figure 1). Then,
equally adjust engine slide plate bolts to desired
position (See Figure 2).
− Proper tension of drive belt is 5/32” deflection
at center of span between pulleys with 10 lbs. of
pressure applied.
− Too much tension results in excessive wear and
stress on flywheel shaft bearings.
− Belts tend to “seat-in” during the first few hours
of operation. Carlton recommends adjustment
of belt tension after the first two hours of
operation.
− Replace belts when worn or when repeated
adjustments are necessary. Belts should never
get so loose that all of the adjustment capability
is used.
− Check break pads for wear (See Figure 3).
− Check cutter wheel, pockets, and teeth for wear.
If any repair is needed, see “Servicing cutter
wheel” Section for further instruction.
− Make sure all teeth and pockets are tightened.
− Tighten pocket bolts to 150 ft-lbs.
Figure 3
Figure 2
Figure 1