Specifications

MACHINE OPERATION
7
• NEVER ATTEMPT TO MAKE ANY
ADJUSTMENTS TO THE UNIT WHILE
ENGINE IS RUNNING (EXCEPT WHERE
SPECIFICALLY RECOMMENDED).
• KEEP ENGINE IN GOOD CONDITION. KEEP
ALL SHIELDS IN PLACE AND SAFETY
DEVICES OPERATING PROPERLY.
• DO NOT TOUCH EQUIPMENT PARTS THAT
HAVE MIGHT BE HOT FROM OPERATION.
BEFORE ATTEMPTING TO MAINTAIN,
ADJUST OR SERVICE, ALLOW SUCH PARTS
TO COOL.
• IF EQUIPMENT VIBRATES ABNORMALLY,
STOP ENGINE AT ONCE. ABNORMAL
VIBRATION IS A WARNING OF TROUBLE.
REPAIR ANY DAMAGE BEFORE
RESTARTING UNIT.
• WEAR EYE PROTECTION. WEAR STURDY
FOOTWEAR. DO NOT WEAR LOOSE
CLOTHING THAT MAY GET CAUGHT IN
ROTATING PARTS.
• Position machine in front of stump with cutter wheel
a slight distance away from stump
(see Figure 5).
• Apply the brake (see Figure 6).
CAUTION: BRAKE ONLY LOCKS ONE WHEEL
AND ALLOWS THE MACHINE TO PIVOT
FROM SIDE TO SIDE.
• Increase engine RPM to full (see Figure 7).
CAUTION: CUTTER WHEEL IS ENGAGED
WITH INCREASED RPM.
• Test controls for proper operation, speed, and
unobstructed movement.
CAUTION:
ALWAYS STAND BEHIND THE
CONTROL HANDLE; NEVER LEAVE THIS
POSITION WHILE CUTTER IS RUNNING.
• Rotate the cutter head back and forth, around
the locked left pivot wheel working down to the
desired depth (see Figure 8).
Figure 5
Figure 6
BRAKE SHOWN IN LOCKED POSITION