Specifications

3500D SERVICING STUB SHAFT
67
• Bolt grease fitting to the air filter
bracket.
• Before starting the engine, apply grease
to the grease fitting until the pin on the
opposite side of the stub shaft pops out
(see Machine Maintenance section for
more information).
• Start replacing parts in the opposite
order in which they were removed.
Replace the v-belt guard and then
replace the engine and jackshaft sheaves.
Torque the bolts in the sheaves to 30 ft.
lbs. Be sure to bolt the belt keepers onto
the stub shaft plate before you put the
engine sheave on, it will be easier that
way.
• Replace the v-belt and align the sheaves
as instructed in the Servicing Belt
Section of the manual. Adjust sheaves
as necessary to get the proper belt
alignment. Check belt tension and set as
described in Servicing Belt section. Belt
alignment and tension are very important
for long bearing life. Always replace
belt guard cover before running the
machine.
DO NOT RUN MACHINE WITHOUT
ALL GUARDS IN PLACE AND
SECURED PROPERLY.