Specifications

3500D MACHINE MAINTENANCE
24
• Check cutter wheel, pockets, and teeth for
wear. If any repair is needed, see Servicing
Cutter wheel section for further instructions.
DO NOT OPERATE STUMP CUTTER
WITHOUT A COMPLETE SET OF
TEETH.
Always clean tip of grease gun fitting and grease fitting on machine before attaching hose
to prevent dirt from being forced into machine parts.
• Grease engine slide assembly daily. Use
Texaco® Starplex II grease. Wipe off
excess grease. Excess grease will attract
dirt.
• Grease engagement arm pivot weekly, 2
places. Use Texaco® Starplex II grease.
Wipe off excess grease. Excess grease will
attract dirt.
• Grease jackshaft bearings daily. There is a
cover on the jackshaft bearings with slots to
access the grease fittings. These bearings
should be purged using grease
EVERYDAY. Purge until clean grease is
seen. Use Texaco
® Starplex II grease.
Wipe off excess grease. Excess grease will
attract dirt. Always clean tip of grease
gun fitting and grease fitting on machine
before attaching hose to prevent dirt from
being forced into machine parts.
JACKSHAFT BEARING GREASE FITTING
ENGAGEMENT HANDLE GREASE FITTING
ENGINE SLIDE GREASE FITTING