User's Manual

Trailblazer Installation and User Manual version 1.03
iv
Incidence of Harm
If your telephone equipment causes harm to the telephone network, the telephone company may
disconnect your service temporarily. When possible, the telephone company will notify you in advance. If
advanced notice is not practical, you will be notified as soon as possible. You will also be informed of your
right to file a compliant with the FCC.
Rights of the Telephone Company
Your telephone company may make changes in its facilities, equipment, operations or procedures that
could affect the proper functioning of your equipment. In this case, you will be notified in advance to give
you an opportunity to maintain uninterrupted telephone service.
Coin Service or Party Use Line
This equipment may not be used on the coin service provided by the telephone company. Connection to
party lines is subject to state tariffs.
Compliance and US Regulatory Information
Model TB 5.9
FCC Reg No., Part 68
BMD8 USA – 27773-PT-E
FCC Reg No., Part 15
FCCID: OPA-TB59
Industry Canada CS-03
3448A-10241A
Industry Canada RSS-210
3448A-TB59
Compliance Classification
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Radio Interference: Carlson Wireless USA Model TB59
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation. Changes of modification not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.