User's Manual

Trailblazer Installation and User Manual version 1.03

Figure 7: Pole mounting the Trailblazer enclosure

Pole Mounting Instructions:

 Attach the mounting flanges to the enclosure using the ¼ -20 x 1” bolts,

¼” flat washers, ¼” lock washers, and ¼” hex nuts.

 Tighten the ¼” nuts to maximum of 25 in-lbs (2.1 ft-lbs). Do not over

tighten!

 Position the enclosure on the pole.

 Place the U-bolts around the pole, and slide the pipe flanges over them

with the serrated sides facing the pole. See figure 1.

 Apply an anti-seizing compound to the threads of the U-bolts.

 Slide the mounting flanges (now attached to the enclosure) over the U-

bolts and secure them using the 5/16” lock washers and 5/16” hex nuts.

 Tighten the 5/16”nuts. Do not over tighten!

4.2 External Antennas

The use of an external antenna with Model Trailblazer RC Pro system mandates

professionally trained personnel to ensure compliance with FCC rules and regulations.

Specifically the installer must ensure that the EIRP of the transmitting antenna does not

exceed the requirements of the Code of Federal Regulations, Title 47, Part 90 subpart