User's Manual

Trailblazer Installation and User Manual version 1.03
21
To set for Star topology or Point-to-Point and Bandwidth of the Base unit:
This is set using the EEprom register “E”.
If the first digit of the switch setting or “most significant digit” is an “8” then it is planned
to be in point-to-point mode. If the first is “0” or none then it will be in Star mode.
The second digit or “least significant digit” is for the bandwidth (as transmitted from the
base unit) with the number corresponding to how many 64 kb channels are made
available.
For example, type in though Hyper terminal or the GUI window [wee e 84]
The system should respond back with [000E: 84]
This will set up a Point to Point with 256 kb available bandwidth.
Entering [wee e 08] would set the radio to be a Star with 512 kb bandwidth.
To allocate total data Bandwidth of the base unit:
To allocate data channels in 64kbps increments, EEprom register “F” is the total number
of data channels allocated to the Base unit.
To allocate total data Bandwidth of the CPE terminal:
To allocate channels to the CPE stations, the EEprom registers 10,11,12,13 are used.
This will handle up to (4) CPEs in a star configuration.
In the CPE, EEprom registers 10,11,12,13 the MSB is used to state the amount of 64kb
channels bonded for data. The LSB is used to state the number of 64kb channels
available for voice services. See the following table for some example scripts.
Point to Point
Point to Point
Star
256kb bandwidth, 2 data channels
and 2 voice channels:
256kb bandwidth, 3 data channels
and 1 voice channel:
512kb bandwidth, 2 voice
channels for each CPE:
wee e 84
000E: 84
wee e 84
000E: 84
wee e 08
000E: 08
wee f 02
000F: 02
wee f 03
000F: 03
wee f 00
000F: 00
wee 10 22
0010: 22
wee 10 31
0010: 31
wee 10 02
0010: 02
wee 11 00
0011: 00
wee 11 00
0011: 00
wee 11 02
0011: 02
wee 12 00
0012: 00
wee 12 00
0012: 00
wee 12 02
0012: 02
wee 13 00
0013: 00
wee 13 00
0013: 00
wee 13 02
0013: 02
reset
reset
reset