User's Manual

Trailblazer Installation and User Manual version 1.03

The radio frequency and scrambling code of the Carlson Wireless radios operate on

numerous band selections based on purchased configuration. Within the selected

operational band, multiple frequencies are provided in combination with code variations.

Selections within the offered band are provided using the 16 position rotary switch

located between the 10BaseT port and the white three pin connectors. The tables

below show the switch settings for the 16 frequency/code combinations for each band

currently offered.

Channel 

5.875 GHz

5.905 GHz

code 0

code 1

code 2

code 3

Table 5: 5.8-9 – Frequency/Code Switch Matrix

3.3.1 Selecting the CPE Time Slot

Up to (4) CPE units can communicate with each Base unit when used in a STAR

topology. To distinguish between the four CPEs, a different time slot is allocated to each

CPE using the rotary DIP switch located immediately behind the LEDs as shown in the

figure below. Use a non-conductive trim tool to select time slots 0, 1, 2, and 3 to avoid

shorting any components. Reset the unit to put your selection in effect by pressing the

reset button located behind the second white three pin connector as shown.

Figure 5: CPE Time Slot Selection Switch

3.4 Allocating Bandwidth to Voice and/or Data

CPE Time

Slot

Selector

Reset

Button