User's Manual
Trailblazer Installation and User Manual version 1.02 17
After you have selected the correct
COM port, the software will display
the connected unit’s current
configuration data.
The screen will look slightly
different depending on whether you
are connected to the CPE or Base
unit. The box highlighted in green
will display the type of unit that is
currently communicating with the
software. All systems are
shipped pre-configured. Do not
change any parameters unless
advised to do so by a CWT
technician. The integrated V.35
data port can be enabled and disabled here as well.
3.1.4 Software Downloads Using the GUI
To download new software, click
on the “Program Download” button
on the Configuration tab and
browse to the location of the file as
shown to the right. For the CPE
units, use the firmware
“station_xxx” file and the software
CPE APPxxx.hex file. For the
Base unit, use the firmware
“station_xxx” file and the software
LINE CARD APPxxx.hex file.
Select the file, and click “Open” to
start downloading.
GUI Showing File Browse
r
GUI showing starting screen