User's Manual

Trailblazer Installation and User Manual version 1.02 22
Each setting is controlled by a short “command name” followed by an EEprom
register or “switch” designated by a letter or letters on your screen. Type the
command name for the function you wish to implement followed by the
appropriate “switch” and press enter. The Trailblazer radio card should respond
by echoing the new setting back to you. It usually takes (7) sets of these
commands to configure a radio card for any of its many functional states. The
settings may be changed one at a time or combined in a text file, known as a
“script”, and loaded into the Trailblazer radio card. See the following table for
details and examples.
Write to
EEprom
register
EEprom
register
0=Star
8=P2P
# of
Total
Ch.
wee e
Write to
EEprom
register
EEprom
register
# of Data
Channels
wee f 0
Write to
EEprom
register
EEprom
register
# of
Data
Ch.
# of
Voice
Ch.
CPE 0 wee 10
CPE 1 wee 11
CPE 2 wee 12
CPE 3 wee 13
reset
Table 10: Commands and switches for bandwidth
To set for Star topology or Point-to-Point and Bandwidth of the Base unit:
This is set using the EEprom register “E”.
If the first digit of the switch setting or “most significant digit” is an “8” then it is
planned to be in point-to-point mode. If the first is “0” or none then it will be in
Star mode.
The second digit or “least significant digit” is for the bandwidth (as transmitted
from the base unit) with the number corresponding to how many 64 kb channels
are made available.
For example, type in though Hyper terminal or the GUI window [wee e 84]
The system should respond back with [000E: 84]
This will set up a Point to Point with 256 kb available bandwidth.
Entering [wee e 08] would set the radio to be a Star with 512 kb bandwidth.