Operator's Manual
Table Of Contents
- 1. Introduction
- 2. Pre-test and System Planning
- 3. Installation
- 4. Configuration and Setup
- 5. Operation and Management Center (OMC)
- 6. Appendices
PRELIMINARY RELEASE
*** This is a confidential document. Do not distribute. ***
Figure 18: Carlson Basestation Rear Panel
The rear pa
nel of the Basestation has the following ports:
A. Heat Sink
B. Radio Board Ethernet Port*
C. Mini USB Diagnostic Port (Unused)
D. RF Port
E. GPS Antenna Port
F. Serial Port (Unused)
G. VGA Port (Unused)
H. USB Ports (Unused)
I. Base Controller Board Ethernet Port*
J. Ethernet Port (Internet in/out)
K. AC Power
*Base Controller Board and Radio Card Connected via Ethernet Cable
4.2. CPE (Customer Premise Equipment)
The CPE, also call "Client Station", is installed at the subscriber’s premises. RuralConnect®
CPEs use external antennas that operate over the entire UHF band; from 470 MHz to 698 MHz.
Speak to your Carlson Sales Representative about the antenna selection available.
ses. RuralConnect®
CPEs use external antennas that operate over the entire UHF band; from 470 MHz to 698 MHz.
Speak to your Carlson Sales Representative about the antenna selection available.
Figure 19: Carlson Basestation Ethernet Cable Connections
Figure 20: RuralConnect® CPE
Page | 17