User's Manual

FT-512 Trailblazer Installation and User Manual version 1.09 iv
Connection to the Telephone Network
The equipment complies with Part 68 of the FCC rules. You will find the label located on the
device. This label contains the FCC Registration Number and the Ringer Equivalence Number
((REN) for this equipment. You must, upon request, provide this information to your telephone
company.
The REN is useful to determine the quantity of devices that may be connected to the telephone line
and still have all of those devices ring with an incoming call signal. In most areas the sum of the
REN’s of all devices connected to one line should not exceed five (5.0). Confirm the number of
devices possible on the telephone line (in REN) by contacting the local telephone company who
provides the service.
Incidence of Harm
If your telephone equipment causes harm to the telephone network, the telephone company may
disconnect your service temporarily. If possible, they will notify you in advance. But if advance
notice is not practical, you will be notified as soon as possible. You will be informed of your right to
file a compliant with the FCC.
Rights of the Telephone Company
Your telephone company may make change in its facilities, equipment, operations or procedures
that could affect the proper functioning of your equipment. If they do, you will be notified in advance
to give you an opportunity to maintain uninterrupted telephone service.
Coin Service or Party Use Line
This equipment may not be used on the coin service provided by the telephone company.
Connection to party lines is subject to state tariffs.
Compliance and US Regulatory Information
CERTIFICATIONS AND REGULATORY
FCC Reg No., Part 68
FCC Reg No., Part 15
Industry Canada CS-03
Industry Canada RSS-210/139
BMD8 USA – 27773-PT-E
OPA-FT-512
3448-10241A
3448-FT-512
RADIO INTERFERENCE
Carlson Wireless USA Model: FT-512-Trailblazer
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation. Changes of
modification not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.