User's Manual

FT-512 Trailblazer Installation and User Manual version 1.09 23
3.1.7 Choosing Channel Configurations
The channel center frequencies are mapped to a number in the following charts.
They can be configured and downloaded using the FT-512 GUI application
running on a PC, or by using the manual selector switch as described in the
following section.
NOTE: Channels 6 and 11 not used in USA
Table 7: Channel Selection Table
3.1.8 Frequency Selection
This system uses a common channel for administrative setup and tear down of
the link. Start by choosing the administrative or signaling frequency. There is a
drop down menu that appears when selecting the signaling frequency box. For
selecting frequencies for the operating pool simply highlight and then hit the Æ
right arrow key. To remove a frequency from the pool, highlight then hit the Å left
arrow key.
Figure 13: Selecting the Signaling Channel
Once the signaling frequency is selected, the operating frequencies are selected
by highlighting the number desired and then clicking on the single -> right arrow.
There can be as many as 5 operating frequencies in the pool. If transmission is
impaired the system will choose the next frequency in line.
The next group of offset channels
Channel 7 2418 MHz
Channel 8 2430 MHz
Channel 9 2442 MHz
Channel 10 2454 MHz
Channel 11 2466 MHz
The first group of non-overlapping
channels
Channel 1 2412 MHz
Channel 2 2424 MHz
Channel 3 2436 MHz
Channel 4 2448 MHz
Channel 5 2460 MHz
Channel 6 2472 MHz