User's Manual

FT-512 Trailblazer Installation and User Manual version 1.09 iii
SAFETY WARNINGS
Potentially hazardous voltages exist on TELCO lines and associated equipment. Always observe
standard safety precautions during installation, operation, and maintenance of these products. To
avoid the possibility of electric shock, be sure to disconnect the power from the remote power
source before you perform any line connections or repairs. Always disconnect all the cables
connected to the system before disconnecting the grounding connection. After disconnecting the
power allow a few seconds for the internal capacitances to discharge before accessing the boards.
QUALIFIED PERSONNEL WARNING
The installation procedures described in this manual must be performed by qualified personnel
aware of the hazards involved. The personnel involved in equipment installation must be trained in
the installation of telephone equipment and associated power systems; these personnel must
strictly observe all the safety precautions related to the installation of communication equipment.
Never install, remove, or adjust equipment and associated cables. Do not work on roofs, masts, or
towers during a lightning storm.
ATTENTION! STATIC SENSITIVE DEVICES
PROPER HANDLING AND GROUNDING PRECAUTIONS REQUIRED.
Components within the Trailblazer system are sensitive to electrostatic discharge (ESD). To avoid
and prevent ESD damage and device failure maintain proper grounding during configuration, repair
or maintenance. This is achieved through the use of an antistatic wrist strap securely connected to
chassis ground. Do not use conductive tools for adjusting channel select switch.
FCC, RF SAFETY HAZARD WARNING
Due to the energy radiated from the antenna, this product must never be mounted such that the
cabinet containing the antenna can be closer than 2 Meters ( 6.7 Feet ) to any person.
UL INSTALLATION SAFETY INSTRUCTIONS
Never install telephone wiring during a lightning storm.
Never install telephone jacks in a wet location unless the jack is specifically designed for wet
locations.
Never touch telephone wires or terminals unless the telephone line has been disconnected at the
network interface.
Use caution when installing or modifying telephone lines.
!
!