User's Manual

FT-512 Trailblazer Installation and User Manual version 1.09 15
Blue (from the
White/Blue pair)
Tip 0 1
White (from the
White/Blue pair)
Ring 0 2
Orange Tip 1 3
White (from the
White/Orange pair)
Ring 1 4
Red/Blue(both wires) Battery back-up signal 5
Not used 6
White/Green +12V 7
White (from the
White/Brown pair)
+12V 7
White/Grey (both wires) Ground 8
Brown Ground 8
Table 5: Pin out for Battery Backed up Power Supply
Pin 1 on the connector is identified as “PCD” shown in the diagram below. Note
that the surface of pin 1 is slightly darker and appears shiny.
Figure 4: Main 6 Pair Cable Connector
5. With the wires identified, cut them to a length of about 10 centimeters from
the cable jacket. Strip the end of each wire back about 1 cm from the end.
6. Attach the wires to the connector as in Table 4 above.
7. Don’t forget to connect the battery up as shown: