User's Manual

FT-512 Trailblazer Installation and User Manual version 1.09 14
charge a 2.2 amp sealed lead acid battery. Connection to line voltage is via a
standard IEC line cord. Termination of the low voltage DC is by screw terminal.
Figure 3: Power Supply Connections
The 2-Line RAU connects to the power supply through a standard 6-pair shielded
cable. The cable is terminated at the power supply end with a “removable”
terminal strip. This is a single-row connector with screw terminal connections for
the cable wires.
The best procedure to follow in assembling this cable is as follows:
1. Strip back about 35 centimeters of the cable outer jacket and shield.
Remove the white streamer and clear plastic covering. This reveals the pairing of
the wires.
2. Install the Scotchlok
TM
4460-D shield connector to the cable shield. Follow
the instructions included with the shield connector.
3. Separate the wires for termination to the connector as described below:
The standard cable pairs are colored as follows:
White/Blue
White/Orange
White/Green
White/Grey
White/Brown
Red/Blue
NOTE: It is important to keep this pairing intact since all the white wires look the
same. The wire color assignment is as follows:
Wire color Function Connector Pin Number