Cut Sheet

Installation
Installation
Installation - Chime Kits
Two Button Chime
• Always turn off house power before beginning
installation.
• Choose a location for your chime receiver which allows
it to be seen as well as heard.
• Mount the transformer to a junction or circuit breaker
box. Attic location is not recommended
• Using wire nuts, connect power transformer leads to
house power leads.
• Extend standard bell wire from transformer and
pushbutton(s) terminals to chime. See wiring diagram
above for assistance. Be sure to label all wires (front,
rear, transformer).
• Insert wires through holes in base and mount base,
using provided screws.
• Connect labeled wires to correct terminal screws. See
wiring diagram to the left.
• Position chime cover securely over base.
• Simple chime replacement does not involve the
transformer and it is not necessary to disconnect power
source
. If old transformer does need replacement, turn
off house power before beginning installation.
• Remove the chime cover from the base. Disconnect the
wires from terminal screws, marking them front, rear,
transformer as they are moved.
• Remove existing chime base from the wall. Insert wires
through hole in new chime base and mount base, using
provided screws.
•
Connect labeled wires to correct terminal screws
. See
wiring diagram to the left for assistance
.
• Position chime cover securely over base.
Stucco Chime
Front
Rear
Front
Rear
16V,
10VA
Trans
Fr
ont
16V,
10VA
Trans
Trans
Front
Rear
T
rans
www.carlon.com
5
Mounting tube
Lid