Installation Procedures Owner manual

MULTI-GARD

INSTALLATION PROCEDURES
www.carlonsales.com
2. Assemble next section of Multi-Gard by applying Carlon Quick-Set™
Cement to the outside of the plain end. Then, push the plain end into the
belled end, checking for print line alignment.
3. Screw a #10 hex head self tapping screw (refer to chart for length)
approximately 3" and 4" from the end of bell at approximately 90°. A total
of 8 screws will give the joint tensile strength given in the table below.
Repeat procedures 2 and 3 on each Multi-Gard PVC section.
Multi-Gard PVC Sections
Part No. Description Length
Screw
Length
Joint
Tensile lbs.
Outer
Dim.
Pkg.
Qty.
Wt. per
100 Ft.
MFSS4S-
020
Type 40 4cell 20' 3/4" 5000 4.5 960' 338
MFSS3S-
020
Type 40 3-
cell
20' 3/4" 5000 4.50 960' 340
MDSS4S-
020
Type 80 4-
cell
20' 3/4" 5000 4.75 760' 450
MDSS3S-
020
Type 80 3-
cell
20' 3/4" 5000 4.75 760' 452
Bore Accessories
Part No. Description Pkg. Qty Wt. Ea. (lbs.)
MAG4
4.25 - 4.487 Meshgrip (7,000 wk. load)
58"
1 2.7
VC9982 Carlon Quick-Set Solvent Cement Quart 12 2.4
Gross Automation [phone] · www.carlonsales.com · [e-mail]