Installation Guide

www.tnb.com
United States
Tel: [phone]
800.816.7809
Fax: [phone]
Technical Services
Tel: [phone]
A-108
Low-Voltage Structured Cable Management System
Boxes & Covers — Carlon
®
Non-Metallic Boxes
Why waste time mounting, then trying to line up separate high-voltage and low-voltage boxes, and still end
up with something not quite right? Our Dual-Voltage Box/Bracket lets you do it all in one fast, easy step with
perfect alignment every time.
Our Low-Voltage Brackets are open-backed to easily accommodate the bend radiuses required for low-
voltage cabling and deep devices such as volume controls, while molded-in ports make it easy to connect
flexible raceway for future-proofing. Or, you can use them to tie off cable to the bracket. They can also be
attached to wood or steel studs.
Dual-Voltage Box/Bracket
Here’s a smart alternative for
where
you would normally use
separate high-
and low-voltage
boxes. Designed to fit a standard
two-gang faceplate, this component
combines an electrical box and
low-voltage bracket into a single
unit for fast, easy installation. No alignment tools are
required and easy nail-on mounting provides precise
placement and a professionally finished appearance.
Resi-Rings accept
3
⁄4" Resi-Gard
®
fittings only...SC200DV
1
1
2
3
Attaching the Add-On Bracket is a “snap.” You just remove the back of the double-sided tape (1), clip
the bracket in place (2) and press on the bracket to secure it against the box (3). Enables the installation
of most rectangular yoke plates.
Low-Voltage
Add-On Bracket
This low-voltage bracket provides
a low-voltage outlet next to a
previously installed high-voltage
outlet. Great for both new
construction and rework, it
attaches easily to most electrical
boxes and is designed to fit a standard two-gang
faceplate. Resi-Rings accept
3
⁄4" Resi-Gard
®
fittings
only…SC100SC
2
Our Low-Voltage Adjustable Brackets simplify installation with tile, paneling or stucco to save you time and
effort. Just use the quick-mount bracket to clip it to the stud (1), add a screw for extra support if you want it
(2), then use the adjustment screw to accommodate wall thickness (3). Also available in a two-gang version.
Low-Voltage
Adjustable Brackets
Our Low-Voltage Adjustable
Brackets are the perfect solution
for tile, paneling or stucco. A
bracket enables quick, easy stud
mounting and a turn of the screw
adjusts to any wall thickness. It’s
great for retrofit/installation upgrades. Replace the
single-gang bracket with a two-gang bracket or switch
services to a high-voltage Adjust-A-Box
™
device…
SC100ADJC (shown) and SC200ADJC
3
Low-Voltage Brackets
Here’s the fast installation choice
when only low voltage is required.
Designed to fit a standard one-,
two- or three-gang faceplate,
these low-voltage brackets
feature an easy nail-on mounting
or screw-in bracket, while a hard
shell provides increased durability and no racking.
Resi-Rings accept
3
⁄4", 1" and 1
1
⁄4" Resi-Gard
®
fittings
(one- and two-gang versions only)… SC100A,
SC200A (shown) and SC300A
4
1
2
3