Product Brochure

Door Chimes
M-6
Door Chimes
• Connect Extend-A-Chime
®
transmitter
to existing mechanical door chime
• Press existing doorbell button
• Existing doorbell rings and sends
signal to Extend-A-Chime
®
• Extend-A-Chime
®
rings
• Extend-A-Chime
®
may be placed
anywhere user wants to hear
doorbell ring: laundry room,
garage, work shop, deck, etc.
Installation — Extend-A-Chime
®
Changing
tone/melody
selection.
To change tone to different tone
or melody, press once on the
small raised button located on the top of
the button. Receiver will play next selection.
To continue changing melody or selection,
press down once again and wait for
receiver to confirm change.
Installation — RC3250 & RC3252
Mounting back cover
of door chime button.
NOTE: Mounting door chime button on aluminum
siding or metal door frame may reduce range.
If you want to cover the wire hole from your
existing button, save mounting of the new
door chime button until after removing
the existing button.
1. Remove cover from back of button by
inserting ballpoint pen into round hole at
bottom of transmitter and gently pushing
in on tab. Lift chime button cover away
from the back plate.
2. For tape mounting:
A.) Make sure surfaces are free of dust,
oil and other substances that could
affect adhesion.
B.) Attach double-sided tape to chime
button back cover
C.) Making sure that the end with the hook-
shaped latch is facing down, press cover
firmly to mounting surface.
3. For screw mounting:
A.) Place chime button back cover where
desired and mark screw locations.
B.) Place chime button back cover against
mounting surface and screw into marked
locations using screws enclosed (may
require drilling pilot holes on hardwoods).
Press to
change
tone
Installation
tnb09_gm102_M_06_07:tnb09_gm102_M_06_07 10/19/09 6:02 PM Page M-6