Product Brochure

Door Chimes
M-5
Door Chimes
Installation — Chime Kits
Two-Button Chime
• Always turn off house power before beginning installation
• Choose a location for your chime receiver which enables
it to be seen as well as heard
• Mount the transformer to a junction or circuit breaker box.
Attic location is not recommended
• Using wire nuts, connect power transformer leads
to house power leads
• Extend standard bell wire from transformer and
pushbutton(s) terminal(s) to chime. See wiring
diagram left for assistance. Be sure to label
all wires (front, rear, transformer)
• Insert wires through holes in base and mount base
using provided screws
• Connect labeled wires to correct terminal screws.
See wiring diagram to the left
• Position chime cover securely over base
Stucco Chime
Front
Rear
Front
Rear
16V,
10VA
Trans
Front
16V,
10VA
Trans
Trans
Front
Rear
Trans
Mounting tube
Lid
• Simple chime replacement does not involve the transformer
and it is not necessary to disconnect power source. If old
transformer does need replacement, turn off house power
before beginning installation
• Remove the chime cover from the base. Disconnect
the wires from terminal screws, marking them front,
rear and transformer as they are moved
• Remove existing chime base from the wall. Insert
wires through hole in new chime base and mount
base using provided screws
• Connect labeled wires to correct terminal screws.
See wiring diagram above for assistance
• Position chime cover securely over base
tnb09_gm102_M_04_05:tnb09_gm102_M_04_05 10/19/09 5:59 PM Page M-5