Datasheet

Specifications are subject to change without notice (30.01.2018) 13
Mounting Instructions
Thermal stress will reduce the lifetime of the SSR. Therefore it is
necessary to select the appropriate heatsinks, taking into account
the surrounding temperature, load current and the duty cycle.
A fine layer of thermally conductive silicone paste must be evenly
applied to the back of the SSR. RGS should be mounted on
the heatsink with two M5 x 30mm screws (SRWKITM5X30MM).
Gradually tighten each screw (alternating between the two) until
both are tightened with a torque of 0.75 Nm. Then tighten both
screws to their final mounting torque of 1.5 Nm.
In case of a thermal pad attached to the back of the SSR, no thermal
paste is required. The RGS is gradually tightened (altering between
the 2 screws) to a maximum torque of 1.5Nm.
M5 x (18mm + thread depth in heatsink).
Mounting screws available with Carlo Gavazzi heatsinks.
Use thermal transfer material (thermal paste or thermal pad)
1.5 Nm