User manual

UDM 35/40 PANEL METER USER MANUAL
11
Navigating & Programming within the Linearization Menu
As appears, press followed by and keys to choose to
ignore or enable linearization . Press to confirm your choice
and advance to next step. If you chose YES, you will be prompted to
enter the number of Linearization Points, using the escape
button to select the position, and the up /down buttons to select
the numerical value, from 01-16. Press enter to confirm and advance.
Next, the correlation between the inputs and outputs must be defined in
the program.
“In.01” will be displayed. Press to toggle through the positions, and
use the and keys to select the value. Press to confirm and
advance. “Ou.01” will display next. Again, using the escape key ,
toggle to the appropriate position. Use the and keys to select the
value. Press enter to confirm and advance. Repeat this procedure for
each set of Inputs and Outputs, up through a maximum of 16. Press the
enter key to confirm. Press to advance to the next program step
sequence.
Alarm Set-point Programming
Up to 4 alarm set-points may be configured. You may configure each set
point using the following parameters, in order, as shown below:
Minimum set-point limit
Maximum set-point limit
Set-point setting