User manual

UDM 35/40 PANEL METER USER MANUAL

Decimal Point Position (dP)

The decimal point position is relative to the Display Value, which will be

discussed next.

When “dP” is displayed, press .

Using the and keys, select the

decimal point position and press

to confirm and advance to next step,

“Lod” and “Hid”, the display span parameters.

Display Span (Lod and Hid)

Allows the user to define the actual display span (in engineering units)

corresponding to the previously defined electrical input range (HiE and

LoE). The “Lod” value represents the minimum displayed value; “Hid”

represents the maximum displayed value.

When “Lod” appears, press key to toggle to proper digit. Use the

and keys to select desired value. Repeat procedure until all digits

have been set, press to confirm and advance to the next step, “Hid”.

Repeat the same procedure to select and confirm the “Hid” values. Press

to confirm. Press to advance to the next program step sequence.