Installation Instructions
SBPSMWBAT
14/12/2018
Each sensor has a unique SIN number. When the conguration is nished, the sensor’s SIN number is visible
in the Carpark 3 conguration software.
The sensor has a built-in red LED. This LED is mounted on the rear side of the sensor, so it is not visible when
the sensor is installed in the base. The LED indicates the status of the sensor and can be used before and
during installation. The different LED status indications are described in the section "LED".
The installer must use the SBP conguration tool to discover and assign a position to the wireless sensors.
The sensors must be entered in consecutive order; otherwise, you will not know their position in the parking lot
Calibration is essential and can only be performed when the parking space is empty. When the sensor is
assigned a position and calibrated, it is fully operational.
When the two parts are to be assembled, it is vital that they are dry and clean. Even though the sensor is
moulded and protected, there is a high risk of water penetration if this precaution is not observed.
The tightening torque as described in the section "Housing" must be respected.
References
Accessories
Item Item number
Anti-vandal torq bit T10 44849
4 M3*16 T10 screws 44823
Product selection key
SBPSMWBAT
Code Option Description
SB - Smart Building
P - Parking
S - Sensor
M - Magnetic
W - Wireless
BAT - Battery
COPYRIGHT ©2018
Content subject to change. Download the PDF: www.productselection.net
Carlo Gavazzi Controls S.p.A
6