Owner's manual

Model 702G/O Advanced gas/oil burners — Instruction manual
Carlin part number MN702GO Rev. 06/23/14
– 16 –
Where appliance instructions differ from this manual, follow the appliance instructions.
Figure 13 702G/O burner wiring using Honeywell RM7897C primary control (see appliance manual or separate wiring information for
burner equipped with a primary control not covered in this manual); see Figure 12 for a legend to callouts.
5. Wire the burner — RM7897C primary control
Wire the burner (RM7895CorRM7897Cprimarycontrolonly)
1. Allwiringmustcomplywith:
• IntheU.S.—theNationalElectricalCode,ANSIZ223.1/NFPA54.
• InCanada—theCanadianElectricalCodePart1,CSAstandardC22.1.
• Allapplicablelocalcodes/standards.
2. ConnecttheburnerfollowingFigures13and14andanyspecialinstructions
orwiringdiagramsprovidedwiththeappliance,burnerorothercomponents.
3. Theburnerrequiresa120VAC/60hz/single-phasecontrolpowersupply,with
a10-ampfuse.Thecontrolcircuitcurrentdrawisapproximately1.2amps.An
additionalpowersourceisrequiredforthemotor(120VACor208-220VAC,
60hz),withfusesizedaccordingly.SeeFigure14foreldwiringconnections.
4. ReadtheHoneywellRM7897Cinstructionsforinformationonsettingaroom
thermostat,ifused.
5. Makesuretheburnerandappliancearecorrectlywiredandthelineswitch
isproperlyfusedfortheload.
 Turnoff power to appliance when servicing burner.
Failure to comply could result in severe person-
al injury, death or substantial property damage.
Figure 12 Legend for Figures 13 and 14