Instruction Manual

Model 301GAS burner — Instruction manual
Carlin part number MN301GAS Rev. 03/14/11
– 2 –
Where appliance instructions differ from this manual, follow the appliance instructions.
PLEASE read this first . . .
Special attention flags
Please pay particular attention to the following when you see them through-
out this manual.
Notifies you of hazards that WILL cause severe personal
injury, death or substantial property damage.
Notifies you of hazards that CAN cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor per-
sonal injury or property damage.
Notifies you of special instructions on installation, operation or
maintenance that are important, but are not normally related
to injury or property damage hazards.
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property damage.
Installer/service technician . . .
• Readallinstructionsbeforeproceeding.Performallprocedures,
and in the order given to avoid potential of severe personal injury,
death or substantial property damage.
• Beforeleavingthesiteafterstart-uporservice,reviewtheUser’s
information manual with the user. Make the user aware of all
potential hazards and perform the training outlined below.
Train the user . . .
• Toproperlyoperatetheburner/applianceperthismanualandthe
appliance instructions and the User’s information manual.
• Tokeepthismanualatorneartheburner/applianceforreadyac-
cess by the user and service technician.
• Tocontacttheservicetechnician,gassupplierorredepartment
should the user smell gas.
• Tokeeptheappliancespacefree of flammable liquids or vapors
and other combustible materials.
• Donotuselaundryproducts,paints,varnishesorotherchemicals
intheroomoccupiedbytheburner/appliance.
• Tocontacttheservicetechnicianatleastannuallyforstart-upand
burner/applianceservice.
When servicing the burner . . .
• Disconnect electrical supply to burner before attempting to
service to avoid electrical shock or possible injury from moving
parts.
• Burnerandappliancecomponentscanbeextremelyhot.Allow
all parts to cool before attempting to handle or service to avoid
potential of severe burns.
General information
Burner applications
Follow all instructions in this manual and the appliance manual. Where ap-
pliance instructions differ from this manual, follow the appliance instructions.
Read the label attached to the burner air tube to verify the burner is correct
for the appliance being used. See page 8 for procedures.
Damage or shortage claims
The consignee of the shipment must file damage or shortage claims im-
mediately against the transportation company.
When calling or writing about the burner . . .
Please provide us with the UL serial number and burner model number to
assist us in locating information. Enter this information on the Installation
Certificate in this manual. The certificate information can be helpful when
troubleshooting or obtaining replacement parts.
Fill out burner adjustment label
Fill out the burner adjustment label, located on the housing above the rating
label after completing installation and burner setup.
Should overheating occur: (1) shut off the manual gas control
to the appliance, (2) do not shut off the control switch to the
pump or blower.
Codes and standards
 Theinstaller/servicerissolelyresponsibleforcompliancewith
all applicable codes and standards.
Burner listings
Carlin 301GAS burners are tested and approved under standards UL795
and CGA 3.4-latest edition.
Codes
Burner/applianceinstallationsmustcomplywithallapplicablelocalcodes
and, where applicable,with the National Fuel Gas Code,ANSI Z223.1/
NFPA54-latestedition,andtheNationalElectricalcode,ANSI/NFPA70-latest
editionforU.S.installationsorB149.1/B149.2InstallationCode,andCSA
C22.1 Canadian Electrical Code Part 1 for Canadian installations.