Technical data

Vario II series
Error correction
06/10
Operating manual
97
11 Error correction
Line rises up completely or partly
over the upper edge of label.
Move line down (increase Y
value).
Check rotation and font.
Line rises up completely or partly
over the bottom edge of label.
Move line up (reduce Y value).
Check rotation and font.
One res. several characters of
the text is res. are not available
in the selected font.
Change text.
Change font.
Selected code is not available.
Check code type.
Selected position is not
available.
Check position.
Selected font is not available.
Check font.
Selected font is not available.
Check font.
While measuring no label was
found.
Set label length is too large.
Check label length and if labels
are inserted correctly.
Restart measuring anew.
No label available.
Soiled label photocell.
Labels not inserted correctly.
Insert new label roll.
Check if labels are inserted
correctly.
Clean the label photocell.
During the print order the ribbon
roll becomes empty.
Defect at the transfer ribbon
photocell.
Change transfer ribbon.
Check transfer ribbon photocell
(service functions).
Stop bit error.
Check stop bits.
Check baud rate.
Check cable (printer and PC).
Parity error.
Check parity.
Check baud rate.
Check cable (printer and PC).