Technical data

Function menu
Vario II series
70
Operating manual
06/10
Press key
to arrive at the next menu item.
Autoload:
On: A label which was loaded once from memory card can be loaded
again automatically after a restart of printer.
Procedure: The used label is saved onto memory card. The label is
loaded from memory card and printed. After switching the printer Off
and again On, the label is loaded from memory card automatically and
can be printed again.
The last loaded label from memory card is always again loaded
after a restart of printer.
Off: After a restart of printer the last used label must be again loaded
manually from memory card.
A common use of the functions Autoload and Hotstart is not
possible. For a correct Autoload procedure the Hotstart must be
deactivated in the printer.
Press key to arrive at the next menu item.
Invert label:
On: Label is printed inverse.
Off: Function is deactivated.
Press key
to arrive at the next menu item.
Manual reprint:
Yes: I In case an error occurred and printer is in stopped mode then
you can reprint the last printed labels by means of keys
and .
No: Only blank labels were advanced.
Press key
to arrive at the next menu item.
Zero point adjustment:
Indication of value in 1/100 mm.
After replacing the printhead - the print cannot be continued at the
same position on the label, the difference can be corrected.
The value for zero point adjustment is set ex works. After
replacing the printhead, only service personnel are allowed to
set this value anew.
Press key to arrive at the next menu item.
Automatic return:
On: The label is pulled back immediately after the cut.
Off: The label is pulled back only before the next print.