Technical data

Vario II series
Function menu
06/10
Operating manual
69
Press key
to arrive at the next menu item.
IN signal level:
Indication of signal at which a print order is started.
+
= active signal level is 'high' (1)
−
= active signal level is 'low' (0)
x
= not activated signal level
s
= status can be affected by interface
*
The modification of the signal level is only taken into consideration for
the operating modes I/O static, I/O dynamic, I/O static continuous and
I/O dynamic continuous.
Press key
to arrive at the next menu item.
OUT signal level:
Indication of signal level for output signal.
+
= active signal level is 'high' (1)
−
= active signal level is 'low' (0)
s = status can be affected by interface*
Press key
to arrive at the next menu item.
TRB = Transfer ribbon advance warning:
Before the end of transfer ribbon, a signal is send by the control
output.
Warning diameter:
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control
output when reaching this diameter (measured at transfer ribbon roll).
v = Reduced print speed:
Setting of the reduced print speed. This can be set in the limits of the
normal print speed. Additionally there are the following settings:
−: No reduced print speed
0: Printer stops at reaching the warning diameter and indicates 'ribbon
error'.
Press key
to arrive at the next menu item.
Port test:
Examination of photocell.
To start the port test, press key
and then the received data is
printed.
COM1 =
serial interface
LPT =
parallel interface
USB =
Universal Serial Bus interface
TCP/IP =
Ethernet interface
Press key to arrive at the next menu item.
Hotstart:
On: Continue an interrupted print order after switching on the printer
anew.
(Only if printer is equipped with option memory card)
Off: After switching off the printer the complete data is lost
(see chapter 12.3 Hotstart, on page 110).
*
in combination with Netstar PLUS