Technical data

Function menu
Vario II series
68
Operating manual
06/10
Press key
to arrive at the next menu item.
Printhead temperature:
Indication of printhead temperature. The printhead temperature
corresponds normally to the room temperature. In case the maximum
printhead temperature is exceeded, the current print order is
interrupted and an error message appears at the printer display.
Press key
to arrive at the next menu item.
Motor Ramp:
This function is often used for high printing speed as the tearing of
transfer ribbon can be prevented.
The higher the '++' value is set, the slower the feeding motor is
accelerated.
The smaller the '--' value is set, the faster the feeding motor is
decelerated.
Press key
to arrive at the next menu item.
Cutter photocell:
1 - Printer is equipped with a cutter
0 - Printer is not equipped with a cutter
CH:
1 - The cutter is in the initial position and ready for the cutting
procedure.
0 - The cutter is not in the initial position. Before you are going to
release a cutting procedure you first have to place the cutter in its
initial position.
Press key
to arrive at the next menu item.
Online/Offline:
This function is activated e.g. if the transfer ribbon is to be changed. It
is avoided that a print order is processed although the printer is not
ready. If the function is activated then press the key
to change
between Online and Offline mode. The respective state is indicated in
the display.
Standard: Off
Online: Data can be received by interface. The keys of the foil
keyboard are only active, if you changed in the Offline mode with key
.
Offline: The keys of the foil keyboard are still active but received data
are not processed. If the printer is again in Online mode then new
print orders can be again received.
Press key
to arrive at the next menu item.
Input/Output:
Indication of signal level which indicates the signal a print order is
started.
0 – Low
1 – High